Removable-Media Devices; Removing Removable-Media Devices - DEC 3000 Model 400S Installation & Owner's Manual

Removable-Media Devices

Removing
Removable-Media
Devices
Use the following procedure to remove either a CD-ROM
(RRD43), tape drive (TZK10, TLZ06, or TZ30), or the fixed
half height 3 1/2-inch floppy disk drive (RX26). To remove the
removable-media device, refer to Figure 5–4 and proceed as
follows:
1. Prepare the system according to Preparing for Service earlier
2. Remove the front bezel, and top and front covers according to
3. Loosen the four screws
4. Lift the drive bracket
5. Remove the drive bracket from the chassis.
If replacing a drive, record the switch settings
of the old drive. Set the switches on the new
drive according to these settings. To set the new
drive differently, refer to the DEC 3000 Model
400/400S AXP Options Guide or the DEC 3000 Model
600/600S/700 AXP Options Guide as applicable for
drive setup information.
in this chapter.
Removing the Covers earlier in this chapter.
place. The screws come up through the bottom of the chassis.
Beware of sharp edges when handling the drive
bracket.
in Figure 5–4), and pull it towards the front of the chassis
enough to disconnect the power connector
signal cable from the removable-media device
Removable-Media Devices
Note
holding the drive bracket
Warning
off the locating pins (not shown
and the SCSI
Removal and Installation Procedures 5–9
in
.