Table of Contents
Advertisement
Mounting the
To mount the chassis on the slides, refer to Figure 3–5 and
Chassis on
proceed as follows:
Equipment
Slides
1. Pull both equipment slides
2. Lift the chassis
3. Push the system into the slides until it stops. Then push
4. Secure the system to the front rails by installing four 10-32
Use sufficient personnel and proper equipment
when lifting or moving the rackmount server
system. The fully loaded system weighs 34 kg
(75 lbs).
Stabilize the cabinet before installing the chassis
into the cabinet. Figure 3–5 shows an example of a
cabinet with the stabilizer foot
positions.
and position it so that you can insert the
slide races into the front end of the slides.
down on the two slide locks, and then push the system into
the cabinet.
screws through the system brackets and into the four U-nuts
previously installed on the rails.
Installing the System on Slides
Warning
extended.
out fully to their locked
Installing the Rackmount Server 3–9
Advertisement
Table of Contents
