Silicon - THUNDER TIGER MD500 Assembly Manual

22.
Trial fit the Horizontal Tail onto the vertical fin, note that
flat surface should be facing up and the other side with
the air foil facing down. It might be necessary to file/sand
the contact area on the vertical fin so that they make
perfect contact. Apply epoxy at the contact area and
make sure it is perpendicular after securing it with two
3x18mm Wood Screws and two M3 Washers. Secure two
vertical Tip Fins onto horizontal tail with four 3x8mm
Wood Screws.
23.
Install the big Damper in place as shown then drill 3/8"
(9mm) hole. Never drill the hole on the molded mark as it
is only for reference, please drill the hole and aim to the
damper screw hole.
24.
Remove the damper temporarily and insert the Silicon
Grommet from the inside fuselage then re-install the
damper again. Note the bigger diameter side should be
facing the Damper. Secure the fuselage with 4x10mm
Button Head Screw and M4 Washer.
procedure at the other side.
25.
Locate the small Damper and do the same way you did for
the last two steps.
26.
Secure the fuselage with 4x10mm Button Head Screw and
M4 Washer as shown.
12
Do the same