Table of Contents
Advertisement
installation
|
22
LOW PROFILE FACEPLATE INSTALLATION
1)
Attach the inner faceplate panel to the insert body using 4 screws
in the locations shown below.
2)
Connect the male end black and red fan switch wires to the wire
connectors from the fan speed control.
3) Tuck the wires into the clip to keep them away from the insert using
the clip provided. Attach the clip to the rear of the faceplate to en-
sure that the wires do not touch the side of the unit. The power cord
should be run behind the inner faceplate panel.
919-524
22 |
Regency U31-10 Gas Fireplace Insert
LOW PROFILE FACEPLATE INSTALLATION
Diagram 1
Diagram 2
Diagram 3
Diagram 4
4) Install the on /off switch - fan speed control box to the left hand
bottom leg of the inner faceplate. Controls located on the left side.
5) Feed wires through the left air chamber clip - then clip them it to
lower left of fi rebox as show below.
Diagram 6
6)
Clip the right side air chamber clip as shown below in Diagram 7.
Diagram 7
1
U31
Diagram 5
02/16/15
Wire
feed
Advertisement
Table of Contents
