Table of Contents
Advertisement
installation
|
16
LOG SET INSTALLATION
Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until
they are replaced. Broken logs can interfere with the pilot operation.
The gas log kit contains the following:
a) 02-43
Rear Log
b) 02-45
Front Right Log
c) 02-56
Middle Left Log
d) 02-46
Left Top Log
e) 02-47
Center Log
f)
02-48
Middle Right Log
g) 02-44
Front Left Log
h) 902-154
Embers
i)
902-153
Rockwool
j)
902-179/P Vermiculite
k) 946-669
Platinum Embers
(supplied with packaged manual)
The "02" refer numbers (i.e. 02-43) are
molded into the rear of each log.
Note: Install Optional Brick Panels prior to installing logs.
1) Carefully remove the logs from the box and unwrap
them. The logs are fragile, handle with care - do not
force into position.
2) Sprinkle the vermiculite around the fi rebox base. Take
some of the embers (approx. 1/3 of the bag) and
sprinkle over the vermiculite.
16 |
Regency U31-10 Gas Fireplace Insert
908-783a
GAS INSERT
LOG SET INSTALLATION
Vermiculite
and embers
3) Place Rear Log A)02-43 on the two pins on the rear
log support.
4) Place Front Right Log B)02-45 on the two pins as
shown.
Page 1 of 3
U31-2 / IG34
Vermiculite
and embers
A)02-43
Pins on Rear Log Support
B)02-45
Vermiculite
and embers
03/30/09
Advertisement
Table of Contents
