Stopping Engine 停止引擎 12; Wheel And Tire Preparation 輪胎及輪轂 12; Storing And Maintenance 儲存及保養 12 - THUNDER TIGER Hammer S18 Instruction Manual

15 STOPPING ENGINE 停止引擎
a
a. Pinch fuel tube to stop fuel flow.
b. After stopping the engine, turn off the receiver switch first, then the transmitter.
c. Be careful! The engine and muffler will be getting extremely hot during operation! Don't touch them during or just after operation.
a. 用手捏住輸油管使燃料無法輸送直到引擎停止。
b. 引擎停止後先關掉接收機電源，然後再關發射機電源。
c. 請注意!引擎及排氣管在運轉時或剛運轉後將處於高熱狀態，請勿徒手碰觸。
16 WHEEL AND TIRE PREPARATION 輪胎及輪轂
a
a. Insert the wheel hex adapter into both sides of the front / rear wheel.
b. Install the wheel assembly, lining up the roll pin with the slot in the wheel. Thread on the locknut and washer using nut wrench
supplied.
a. 將六角輪轂轉換器，安裝至前後輪內側。
b. 將輪穀固定銷裝至轉向座外端（如圖示），利用隨車所附版手與固定螺帽將輪胎安裝於車身上。
17
STORING AND MAINTENANCE 儲存及保養
a
d
a. Before storing you car, draw out any fuel from the tank.
b. Next, restart the engine to combust remaining fuel.
c. Unplug the glow plug and put after engine oil inside the engine, re-plug the glow plug.
d. Wipe off the dirt and oil on your car.
e. Make sure you have disconnected the power (batteries).
a. 遙控車長時間不使用時請先使用注油壺將燃油吸乾。
b. 然後重新發動引擎將引擎內剩餘燃油完全燃燒。
c. 將火星塞取下並使用引擎潤滑油保養引擎內活塞，重新裝上火星塞。
d. 清除車體及車殼上之油污。
e. 再次確認電源線(電池)處於非連結狀態。
b
b
b
e
c
c