Table of Contents
Advertisement
ENGINE & FUEL TANK INSTALLATION
V. Engine Installation
Locate the motor mount hardware: two beams, backplate, two anti-
vibration rubber and four machine screws. Install the adjustable engine
mount. Remember to install anti-vibration rubber to reduce the engine
vibration. Set the engine on engine mount as shown, measure from the
firewall to the front of thrust washer at 13.5cm(5 5/16"). Mark the
engine mounting hole position on the engine mounts.
Drill the engine mounting hole with 3.5mm bit(3/16") then using
the four 4x24mm Mounting Screws to secure the engine.
Drill a 3mm(1/8") hole for throttle pushrod guide tube. Install the
pushrod tube and use a couple of drops of medium CA to hold in place
in the firewall.
Install the throttle pushrod. You might need to screw off the throt-
tle lever first then attach to Z-bend throttle pushrod end.
VI. Fuel Tank Assembly
Assemble the fuel tank and install the fuel tank in fuselage.
11
Advertisement
Table of Contents
