Table of Contents
Advertisement
iDEN Lithium Ion battery or may yield reduced number of charge
cycles.
¥ If the battery appears inoperative, the internal protection circuitry
may have been activated. Remove the battery from the phone and put
it into the charger for several minutes to reset the circuitry.
¥ When the battery is not in use, always store it in the safety tray.
Travel Charger
Using the NPN6197 Travel Charger, you can charge a battery from an
AC outlet. On one end of the travel charger, an accessory connector
attaches to the bottom of the phone unit. At the other (AC outlet) end of
the device, there is a compact housing that contains the plug-in power
supply. A lightweight cable connects the two ends (accessory connector
and supply).
A green LED on the accessory power supply indicates that the Travel
Charger is plugged in.
Using the Travel Charger
1. While holding the i2000 phone with its front toward you, insert
the accessory connector (with the Motorola logo facing you) into
the slot on the bottom of the i2000 phone until you hear a click.
2. Plug the Travel Charger transformer into an AC wall outlet. The
power light (green LED) on the accessory power supply will
come on.
Travel Charger Operating SpeciÞcations
Input voltage range: 90-264 VAC @ 50/60 Hz.
Operating temperature range: 0¡C to +50¡C
Accessory Connector
Figure 3. Using the Travel Charger
Travel Charger
Transformer
Accessories
Advertisement
Table of Contents
