Polaris Ranger RZR XP 900 2011 Service Manual page 273

Bearing Carrier Installation
1. Install drive shaft through the backside of the bearing
carrier.
FINAL DRIVE
4. Install rear wheel hub assembly, cone washers, and hand
tighten the castle nut. Install washers with domed side out.
Cone Washers
5. Install the rear brake caliper assembly and new bolts.
Torque to specification.
2. Install the (4) fasteners that attach the rear bearing carrier
to the trailing arm. Install the (1) fastener that attaches the
upper radius rod to the bearing carrier. Torque bolts to
specification.
NOTE: Use new nuts upon installation of the rear
bearing carrier.
~
=T
Bearing Carrier to Trailing Arm Bolts:
50 ft. Ibs. (67.7 Nm)
~
=T
Radius Rod to Bearing Carrier Bolts:
50 ft. Ibs. (67.7 Nm)
3. Apply anti-seize to drive shaft splines.
Wheel
Hub
~
Out
~
=T
Rear Caliper Mounting Bolts:
30 ft. Ibs. (41 Nm)
I
7.25
9923144 - 2011 RANGER RZR XP 900 Service Manual
© Copyright 2011 Polaris Sales Inc.