Daikin FTKS20CVMB Service Manual page 90

SiENBE04-401A
To operate the remote control
•
•
•
To fix the remote control holder on the wall
1. Choose a place from where the signals
2. Fix the holder to a wall, a pillar, or similar
3. Place the remote control in the remote
ATTENTION
About remote control
• Never expose the remote control to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as inverter-type lamps) is in the
room. Consult the shop if that is the case.
• If the remote control signals happen to operate another appliance, move that appliance to some-where else, or consult the
shop.
System Configuration
To use the remote control, aim the
transmitter at the indoor unit. If there is
anything to block signals between the unit
and the remote control, such as a curtain,
the unit will not operate.
Do not drop the remote control. Do not get it
wet.
The maximum distance for communication is
about 7m.
reach the unit.
location with the screws procured locally.
control holder.
Instruction
Receiver
Remote controller
holder
Set.
To remove, pull it upwards.
81