Optional Hardware Requirement; Connecting The Radio To The Computer; Connecting The Radio To The Computer - Motorola SABER RVN4002K User Manual

B. Optional Hardware Requirements
Additional hardware will be required if it is necessary to read, program, or align a SABER radio.
The following section provides a list of required hardware.
Only one of the two cables is required. Choose the appropriate one for your machine.
- Computer Interface Cable ( 25-pin connector cable ):
- Computer Interface Cable ( 9-pin connector cable ):
Radio Interface Box ( RIB ):
RIB Power Supply:
Programming Cable:
For Alignment: ( See items listed in your SABER Service Manual)
- Power Meter
- RF Monitor
- Frequency Generator (10 Hz - 10 kHz)
- Battery Eliminator:
- Portable Products Test Set:
C. Connecting The Radio To The Computer
The SABER radio and the Radio Interface Box (RIB) should be connected to the computer as
described below. Refer to Figure 4.
Computer Interface Cable
P/N: 30-80369B71
or B72
To COM 1 or COM2
Radio Interface Box
15-Pin
RIB
RLN-4008
25-Pin
Program/Test Cable
RTK-4203A
10 Hardware Installation
SABER
RADIO
Figure 4. Connecting the Radio to the Computer
#30-80369B71
#30-80369B72
#RLN-4008A
#01-80357A57 (110V)
#01-80358A56 (220V)
#60-82728J01 (9V)
#RTK-4203A
#RTL-4224A
#RTX-4005B
DOS 3.1
640k
512k RAM
RS-232 Port