Servicing The Radio; How To Set Up; Test Setup For Alignment Procedure - Motorola SABER RVN4002K User Manual

All radio alignment procedures are accessed from the SERVICE menu. A radio must be
connected to your computer via a RIB and cables, and the radio turned ON before you will be
permitted to access the SERVICE screens. Refer to the SABER SERVICE AIDS list in Appendix-
7 for all the service aids, service tools, and recommended test equipment that you may require
to program, align, and test SABER radios.
All SERVICE screens do NOT read and program the radio codeplug directly, you have to use the
READ/WRITE functions before and after using the SERVICE menus.
A. How To Set Up
For setting up to align the radio, follow the procedure in Section III-C: Connecting the Radio To
The Computer, except use the general hardware test equipment shown in Figure 8 for aligning.
Serial Card
IBM PC Computer
Test Equipment
20

Servicing the Radio

VI. SERVICING THE RADIO
Computer Interface Cable
P/N 30-80369B71 or B72
Program/Test Cable
RTK-4203A
Portable
Products
Test Set
RTX-4005B
Figure 8. Test Setup for Alignment Procedure
RIB
RLN-4008
Saber
Battery Eliminator
RTL-4224A