All Load; Single Load - Yamaha RX11 Owner's Manual

All Load

This function loads the entire RX11 pattern and song memory
from the data cartridge. Press the LOAD button in the
cartridge control mode and the LCD panel will respond with
"LOAD ALL MEMORY?". Press +1/YES to continue or
–1/NO to cancel. If +1/YES is pressed the LCD panel will
read "ARE YOU SURE?". Press +1/YES to initiate the
actual load operation or –1/NO to cancel. If +1/YES is
pressed, the LCD panel will display "LOAD COMPLETED!"
for a few seconds before returning to the pattern or song
display. The entire RX11 pattern and song memory now
contains the cartridge data.
All Load

Single Load

This function permits loading a single pattern from the
data cartridge into any RX11 pattern memory location.
First press LOAD in the cartridge control mode, and then
press –1/NO in response to the "LOAD ALL MEMORY?"
display. The LCD panel will respond with "LOAD SINGLE
PTN?", asking you if you wish to load a single pattern.
Press +1/YES to continue, or –1/NO to cancel and return
to the cartridge control mode. If +1/YES is pressed, the LCD
panel will respond with "CRT **
you to input the pattern number to be loaded, and the des-
tination pattern memory number in the RX11. Input the
pattern number to be loaded using the white number keys,
press the +1/YES button, then input the RX11 pattern
memory location number into which the pattern is to be
loaded. Press +1/YES again and the RX11 will reconfirm
your intention to load the pattern with the "ARE YOU
SURE?" display. Press +1/YES to load, or –1/NO to return
to the "CRT XX MEM XX" display, allowing you to re-
enter the cartridge and RX11 pattern numbers. In the latter
Pattern or song mode.
MEM **", prompting
25
case, pressing the –1/NO button returns the cursor to the
"MEM" number, and pressing –1/NO again returns to the
"LOAD SINGLE PTN?" display, from which you can return
to the cartridge control mode by pressing the –1/NO button
again.
To initiate the actual load operation press +1/YES again.
The LCD panel will read "LOAD COMPLETED" for a few
seconds before returning to the pattern or song mode.
The Single Load function does not permit writing a pattern
to an RX11 pattern memory location that already contains
data. If this is attempted, the "ALREADY USED!" display
will appear. Exit to the cartridge control mode by pressing
the CARTRIDGE button.
Single Load
Enter CRT number
Enter MEM number
Pattern or song mode.