Table of Contents
Advertisement
TESTING THE SYSTEM (cont'd)
Walk in front of any interior motion detectors (if used)
and listen for three beeps. The identification of the
detector should appear on the display when it is
activated. The display will clear when no motion is
detected. Note that if wireless motion detectors are
used, there is a 3-minute delay between activations.
This is to conserve battery life.
To test all smoke detectors, follow the manufacturer's
instructions. The identification of each detector should
appear on the display when each is activated.
If a problem is experienced with any protection point
(no confirming sounds, no display), CALL FOR
SERVICE IMMEDIATELY.
When all protection points have been checked and are
intact (closed), there should be no zone identification
numbers displayed on the keypad.
When testing is completed, exit the TEST mode by
continuing with step 5.
5.
+
1
EXIT TEST MODE
(Security Code)
OFF
Enter your security code and press the
key.
1
OFF
If the test mode is inadvertently left active, it
automatically turns off after approximately 4 hours.
–
–
30
Hide quick links:
Advertisement
Table of Contents
