Advertisement
Hydraulic connections
• Connectthe water tube to the
faucet,
only
using the drain tube supplied with the
washingmachine
(fig.
3).
DO NOT OPEN THE FAUCET.
• Some models may includeone or moreof
the
followingfeatures:
• HOT&COLD (fig. 4):
water mains connectionsettings with hot
and cold water for higherenergysavings.
Connect the grey tube to the cold water
faucet
*
and the red one to the hot water
faucet. The machinecan be connectedto
the cold water faucet only: in this
case,
some programs may start a few minutes
later.
• AQUASTOP (fig. 5):
a device located on the supply tube that
stops water flow if the tube
deteriorates;
in this
case,
a red mark will appear in
the
window
"A"
and the tube must be
replaced.
To unscrew the
nut,
press the
one-waylock
device"B".
• AQUAPROTECT
- SUPPLY TUBE WITH
GUARD (fig. 6):
Should water leak from the primary
internal tube
"A",
the
transparent
containmentsheath "B" will containwater
to permit the washing cycle to complete.
At the end of the
cycle,
contact the
Customer Service Centre to replace the
supplytube.
Setting
• Near the washing machine to the
wall,
being
careful
that the tube is not bent or
crushed,
and place the drain tube in the
tub
or, preferably,
connect it to a wall
drain at least 50 cm high with diameter
greater
than the washing machine tube
(fig.
7).
®
I
,
......
/
-
-
-
@)
~~
~
~
1
~*
I
~
I
'-1
\ \
00
o
~
-----------------------------~-----------------------------
Hide quick links:
Advertisement
