Advertisement
The option buttons
should be selected
before
pressing
the
START/PAUSE
button.
If
an
option
is
selected
that
is
not
compatible
with
the
selected
programme then the option indicator
first flashes and then goes
off.
SPIN SPEED button
• By pressing this
button,
it is possible to
reduce the maximum
speed,
and if you
wish, the spin
cycle can
be cancelled.
• To reactivate the spin
cycle
press the
button
until you reach the spin speed you would
like to set.
To prevent damage to the
fabrics,
it is
not possible
to increase
the speed
over
that
which
is
automatically
suitable
during
the selection
of the
program.
•
It
is possible to modify the
spin
speed
without
pausing the
machine.
The machine is fitted with a special
electronic
device, which prevents the
spin
cycle
should
the
load
be
unbalanced.
This reduces the noise and vibration in
the machine and so prolongs the life of
your machine.
TEMPERATURE SELECTION button
• This button allows you to change the
temperature of the wash cycles.
•
It is not
possible to raise the
temperature
over the
maximum allowed for every
programme, in order to
save
the
fabrics.
DELAY START button
• This button allows you to pre-programme
the
wash
cycle to delay the start of the
cycle for up to 24
hours.
• To delay the start use the following
procedure:
-
Set
the
required
programme.
- Press the
button
once to activate it (hOO
appears on the display) and then press
it again to set a 1 hour delay (h01
appears on the
display).
The
pre-set
delay increases by 1 hour
each
time the
button is
pressed,
until
h24 appears
on
the display, at which point pressing the
button again will reset the delay start to
zero.
- Confirm by pressing the START/PAUSE
button (the light on the
display
starts to
flash).
The countdown will begin and
when it has
finished
the programme
will
start automatically.
• It is possible to cancel the delay start by
turning the programme selector to
OFF.
If there is any break in the power supply
while the machine is operating,
a
special
memory stores the selected programme
and,
when the power
is restored,
it
continues where it left OFF
---------------------------~---------------------------
Hide quick links:
Advertisement
