Samsung VP-M50 Service Manual page 85

Alignment and Adjustment
The remote controller (accessory unit) is required to adjust the camera section.
MANUAL
FOCUS
Note : In service adjustment mode, button names are different from those in customer camera function
control mode. EX) MENU ON/OFF button is the same as confirm.
5. How to get into service
STEP 1
1. Remove the lithium battery from the
camcorder.
2. Connect the power source (battery/
DC cable).
3. Eject the tape if it is in the unit.
4. Set the power switch of the
camcorder to "CAMERA" position.
5. Set OSD on state.
Note : When "XX XX" is shown in service adjustment procedures, this indicates variable values.
4-4
DATE/TIME
"ADJUST" mode
EJECT
FAR
NEAR
OSD ON/OFF
STEP 2
1. Press and hold the "EJECT" button and
"DATE/TIME" button on the camcorder at the
same time for more than 5 seconds.
Then unit goes into service mode.
STEP 3
On screen display show "0DF. T.INI XX XX"
CAMERA ADJUSTMENT mode has suc-
cessfully been activated.
DATA DOWN
DATA UP
Confirm
MODE UP
MODE DOWN
Samsung Electronics