Samsung VP-M50 Service Manual page 67

Alignment and Adjustment
4-2-3 CVF Adjustment
Notes :
1. After each adjustment step is completed, OSD shows "OK".
2. EEPROM(ICV02) stores confirmed adjustment value of each adjustment step.
3. After finishing the adjustment, reset the main power source (OFF-ON) to memorize the adjustment data
in EEPROM.
4. Remote controller is used as a CVF adjust tool.
4-2-3 (a) PREPARATION
1. How to get into the CVF adjust mode.
STEP2
1. Connect the power source (battery/DC
cable).
2. Set the mode switch of the camcorder to
"PLAY" position.
3. Set OSD on state.
4. Press and hold the "EJECT" button and
"PLAY" button on the camcorder at the
same time for more than 5 seconds.
Then unit goes into service mode.
MANUAL
FOCUS
Note : When XX XX is shown in service adjustment procedures, this indicates variable values.
4-28
STEP1
Short the two lands on the CVF PCB by sol-
der to Ground. (They are displayed on page
4-31)
STEP3
MONITOR OSD shows "8. PLL EPR XX.
EVR XX". Then CVF adjustment mode has
been activated successfully.
EJECT
PLAY
FAR
NEAR
OSD ON/OFF
8 PLL
EPR : XX EVR : XX
DATA DOWN
DATA UP
Confirm
MODE UP
MODE DOWN
Samsung Electronics