Bridging Settings - Motorola Netopia 3397GP Administrator's Handbook

Your Service Provider will indicate the required vpi number.
set atm [vcc n ] vci { 0 ... 65535 }
Select the virtual channel identifier (vci) for VCC n. Your Service Provider will indicate the required vci
number.
set atm [vccn] encap { ppp-vcmux | ppp-llc | ether-llc |
Select the encapsulation mode for VCC n. The options are:
ppp-vcmux
ppp-llc
ether-llc
ip-llc
pppoe-vcmux
pppoe-llc
Your Service Provider will indicate the required encapsulation mode.
set atm [vccn] pppoe-sessions { 1 ... 8 }
Select the number of PPPoE sessions to be configured for VCC 1, up to a total of eight. The total num-
ber of pppoe-sessions and PPPoE VCCs configured must be less than or equal to eight.

Bridging Settings

Bridging lets the Motorola Netopia® Gateway use MAC (Ethernet hardware) addresses to forward non-
TCP/IP traffic from one network to another. When bridging is enabled, the Motorola Netopia® Gateway
maintains a table of up to 512 MAC addresses. Entries that are not used within 30 seconds are
dropped. If the bridging table fills up, the oldest table entries are dropped to make room for new
entries.
Virtual circuits that use IP framing cannot be bridged.
☛
NOTE:
For bridging in the 3341 (or any model with a USB port), you cannot set the bridge option
off, or bridge ethernet option off; these are on by default because of the USB port.
Common Commands
set bridge sys-bridge {on | off }
Enables or disables bridging services in the Motorola Netopia® Gateway. You must enable bridging ser-
vices within the Motorola Netopia® Gateway before you can enable bridging for a specific interface.
ip-llc | ppoe-vcmux | pppoe-llc }
PPP over ATM, VC-muxed
PPP over ATM, LLC-SNAP
RFC-1483, bridged Ethernet, LLC-SNAP
RFC-1483, routed IP, LLC-SNAP
PPP over Ethernet, VC-muxed
PPP over Ethernet, LLC-SNAP
151