Administrator's Handbook
You can include one or more of the following arguments with the download command. If you omit argu-
ments, the console prompts you for this information.
❑ The server_address argument identifies the IP address of the TFTP server from which you want
to copy the Motorola Netopia® Gateway configuration file.
❑ The filename argument identifies the path and name of the configuration file on the TFTP server.
❑ If you include the optional confirm keyword, the download begins as soon as all information is
entered.
You can also download an SSL certificate file from a trusted Certification Authority (CA), on platforms
that support SSL, as follows:
download [-cert] [ server_address ] [ filename ] [confirm]
install [ server_address ] [ filename ] [confirm]
Downloads a new version of the Motorola Netopia® Gateway operating software from a TFTP (Trivial File
Transfer Protocol) server, validates the software image, and programs the image into the Motorola
Netopia® Gateway memory. After you install new operating software, you must restart the Motorola
Netopia® Gateway.
The server_address argument identifies the IP address of the TFTP server on which your Motorola
Netopia® Gateway operating software is stored. The filename argument identifies the path and name
of the operating software file on the TFTP server.
If you include the optional keyword confirm , you will not be prompted to confirm whether or not you
want to perform the operation.
license [key]
This command installs a software upgrade key. An upgrade key is a purchased item, based on the
serial number of the gateway.
log message_string
Adds the message in the message_string argument to the Motorola Netopia® Gateway diagnostic
log.
loglevel [ level ]
Displays or modifies the types of log messages you want the Motorola Netopia® Gateway to record. If
you enter the
loglevel
displays the current log level setting.
You can enter the
loglevel
messages you want to record. All messages with a level number equal to or greater than the level you
specify are recorded. For example, if you specify loglevel 3, the diagnostic log will retain high-level infor-
mational messages (level 3), warnings (level 4), and failure messages (level 5).
Use the following values for the level argument:
❑
1
or
low
– Low-level informational messages or greater; includes trivial status messages.
134
command without the optional level argument, the command line interface
command with the level argument to specify the types of diagnostic