Motorola BR700 User Manual page 55

SECTION 3
3-24
To access the screen, click NETWORKING > PORT TRIGGER. Click
APPLY to save your settings or CANCEL to cancel changes.
To add a Port Trigger entry:
1 Port Trigger Name: Enter the name of the application. There is a
limit of 32 characters for the name. Click to enable if you wish it to
become active. Otherwise, you can save the information and
enable it at later date. To enable at a later date, select the entry,
check enable, then click Update.
2 Outgoing Protocol: From the drop down box, select from TCP,
UDP, or Both.
3 Outgoing Port: Enter the From and To ranges (0 to 65535) for
your application.
4 Trigger Incoming Protocol: From the drop down box, select from
TCP, UDP, or BOTH.
5 Incoming Port Range: Enter continuous value(s) (0 to 65535),
separated by dashes, for your application. You can also enter
multiple non-continuous values, separated by semicolons.
6 Port Trigger Idle Time: Enter the elapsed time before the port
mapping closes.
To update or remove an entry, select it and then click Update or
Remove to perform the action.
SECTION 3, CONFIGURATION
CONFIGURATION