Motorola SBV5220 User Manual page 47

Introduction
3
Measure the printed template with a ruler to ensure that it is the correct size.
4
Use a center punch to mark the center of the holes.
5
On the wall, locate the marks for the mounting holes.
Caution
Before drilling holes, check the structure for potential damage to water, gas, or electric
lines.
6
See step 6 for recommended mounting hardware size. Drill holes to a depth and diameter appropriate for the
size and type of hardware you have selected.
7
If necessary, install an anchor in each hole.
Use M3.5 x 38 mm (#6 x 1 1/2 inch) screws with a flat underside and maximum screw head diameter of 9.0
mm (.35 inches) to mount the SBV5220.
8
Using a screwdriver, turn each screw until the head protrudes from the wall, as shown:
— There must be at least 2.5 mm (.10 inches) between the wall and the underside of the screw head.
— The maximum distance from the wall to the top of the screw head is 6.0 mm (.24 in)
Note: Example above for mounting SBV5220 on a wood surface.
9
Place the SBV5220 so the keyholes are above the mounting screws.
10
Slide the SBV5220 down so it stops against the top of the keyhole opening.
SBV5220 VoIP Cable Modem User Guide
Installation Troubleshooting Glossary License
38