Panaboard Operation Panel - Panasonic UB-5310 Operating Instructions Manual

■ Panaboard Operation Panel

It is possible to perform the same operations as with the electronic board control panel (page 9) from the following
Panaboard Operation buttons.
Note
• While the Panaboard Operation Panel is displayed, the Copy Key and 2-Screen Copy Key on the electronic
board control panel are used for scanning images into the computer.
Panel
Contrast
Indicator
Contrast Button
2-Screen Scan
Button
Multi-Copy/
Error Indicator
Multi-Copy/Stop
Button
Scan Button
Advance Button
2-Screen Copy
Button
Copy Button
Name
This lamp indicator displays the contrast used during
scanning or copying.
Indicator off: Normal scanning or copying contrast
Indicator on: Darker than normal scanning or copying
Each time this button is pressed, the unit will alternate
between normal and dark contrast modes (Normal/Dark).
This button scans the front and back of the screen on a
single page.
This indicator displays the number of copies to be made.
The display changes each time the Multi-Copy/Stop Button
is pressed.
Example: 1 → 2 → ··· → 9 → 1 → ···
When an error occurs, a flashing symbol will appear in this display to
indicate the error status. (See page 26.)
When making multiple copies, press this button until the
desired number of copies is displayed on the Multi-Copy/
Error Indicator. This button can also be pressed to stop
copying while executing multiple copies.
• The display changes as shown below each time the screen is copied.
After reaching 0, the display will reset to 1.
Example: 5 → 4 → 3 → 2 → 1 → 0 → 1
* If scanning, the setting 1 to 9 for the number of copies is
ignored.
This button scans the screen.
Clicking this button advances the screen from right to left.
This button causes the front and back of the screen to be
copied on a single sheet of paper.
This button causes the screen to be copied.
Description
contrast
(Number is counted down.)
Computer Interfacing
21