4.5
Installation of the lamp house
W
ARNING
C
AUTION
handled.
Necessary tools
•
10 mm nut driver
•
Flat screw driver
How to install the lamp house
1. Grip the lamp house by both handles and place the front of the lamp house on the base plate inside the lamp compartment of
the projector, lining up the foot of the lamp house with the slots on the base.
Image 4-25
Mount lamp house
2. Push the lamp fully into the slots.
3. Secure the lamp house by fastening both captive screws at the base of the lamp house.
Image 4-26
Secure lamp house
R59770491 DP2K-32B 30/04/2010
:
This procedure may only be performed by qualified technical service personnel.
:
Due to its high internal pressure, the lamp may explode in either hot or cold states if improperly
4. Lamp & lamp house
45