4.2
Removal of the lamp house
W
ARNING
W
ARNING
15 minutes before proceeding to remove the lamp house.
C
AUTION
handled.
Necessary tools
•
Nut driver 10 mm
•
Flat screw driver
How to remove
1. Make sure the projector is switched off.
2. Remove the lamp cover.
3. Release both captive screws at the base of the lamp house.
Image 4-5
Loosen lamp house screws
4. Remove the lamp house as follows:
a) Grip the lamp house by the bottom handle and partially slide it out of the lamp compartment
b) Grip the lamp house by both handles and remove it completely from the projector.
c) Place the lamp house on a stable support.
Caution:
Be aware of the weight of the lamp assembly. Take the necessary precautions to avoid personal injury.
R59770491 DP2K-32B 30/04/2010
:
This procedure may only be performed by qualified technical service personnel.
:
The lamp house is very hot after operation. To avoid burns, let the projector cool down for at least
:
Due to its high internal pressure, the lamp may explode in either hot or cold states if improperly
4. Lamp & lamp house
35