camera operation
- SEL POS/ XPOS/ YPOS : Adjust the size and position of the selected area.
- RETURN : Return to the SPECIAL menu.
y Dis (Digital image stabilizer) : This function mitigates any picture movement due to
y ViDEo analYTiCs
❶MM I f the SPECIAL menu screen is
displayed, use the Function Setup
switch so that the arrow indicates
'VIDEO ANALYTICS'.
❷MM S elect a desired mode using the
Function Setup switch.
- TAMPERING : If the screen view
y SENSITIVITY : Set the sensitivity to tampering detection.
y ALARM OUT : Outputting of detection signals can be set.
EXTERNAL : Send signals through external terminals.
`
OSD : Display signals on the screen.
`
RETURN : Return to the TAMPERING menu.
`
y RETURN : Return to the VIDEO ANALYTICS menu.
M
`
In the following cases, the initially set tampering detection function can malfunction.
- In a monitoring environment with a simple background or an environment with low light level or at
night, the detection performance can deteriorate.
- Sudden changes in the lighting and severe camera shaking can be wrongly detected as tampering.
- Immediately after tampering, the camera tampering detection can take up to a max of five seconds.
- If camera tampering is detected, after some time(five sec), stabilization will be done before
restarting. During stabilization, there is no detection.
30_ camera operation
external factors such as wind.
is obstructed or the
camera location
is changed,
tampering
detection, you can
issue an event signal by setting it.
VIDEO ANALYTICS
▶
1. TAMPERING
2. MOTION
3. INTELLIGENCE
RETURN
4.
TAMPERING
SENSITIVITY
▶
1.
ALARM OUT
2.
RETURN
3.
OFF
OFF
OFF
MIDDLE