Samsung SCV-5083R User Manual page 27

- DISP ID : Display camera title on top left corner of the screen.
- FONT COLOR : You can change the OSD font color. (White, Yellow, Green, Red, Blue)
- LANGUAGE : You can select the menu language according to your requirements.
- RETURN : Return to the SPECIAL menu.
y Comm aDJ (Communication adjust-
ment) : This function sets up the camera
communication status when controlling the
camera through an external control device.
- PROTOCOL : Select the
communication
PROTOCOL.
(SAMSUNG-
T,Samsung-E, Pelco-D,
Pelco-P, Panasonic, Bosch, Honeywell, Vicon, AD, GE)
- CAM ID : Determines the camera's identification number (between 0 and 255).
- BAUD RATE : You can select 2400/4800/9600/19200/38400/57600 bps.
- UART MODE : You can select NONE, EVEN or ODD for the parity bits.
- RET PKT : Specify whether to return the same command to the controlling device
when a control command is delivered to the camera.
- COAX : You can select whether to use COAX communication.
- RETURN : Return to the SPECIAL menu.
y imagE aDJ
❶MM I f the SPECIAL menu screen is
displayed, use the Function Setup
switch so that the arrow indicates
'IMAGE ADJ'.
❷MM S elect a desired mode using the
Function Setup switch.
- GAMMA : The setting range is 0.2 ~
1.0. The closer to 1.0 the
setting is, the darker it gets.
→ 0.20, 0.25 , 0.30 , 0.35,
0.40, 0.45, 0.50, 0.55, 0.60, 0.65, 0.70, 0.75, 0.80, 0.85, 0.90, 0.95, 1.0
- PED LEVEL : The setting range is 1 ~ 100. The closer to 100 the setting is, the
higher the PED level gets.
- COLOR GAIN : The setting range is 1 ~ 100. The smaller the setting value is the
smaller the color gain gets and the more color blind it gets.
- H-REV : Flip an image horizontally.
COMM SETUP
▶ 1. PROTOCOL
2. CAM ID
3. BAUD RATE
4. UART MODE
5. RET PKT
6. COAX
7. RETURN
IMAGE SETUP
GAMMA
▶ 1.
PED LEVEL
2.
COLOR GAIN
3.
4. H-REV
5. V-REV
6. D-ZOOM
7. SHARPNESS
8. PFR
RETURN
9.
SAMSUNG-T
1
 --------
9600
8-N-1
ENABLE
ON
0.45
50
---- ----

50
---- ----

OFF
OFF
OFF
MIDDLE
OFF
English_27