Accelerator Pedal Position (App) Sensor Assembly Inspection - Suzuki 2006 SX4 Service Manual

1C-6 Engine Electrical Devices:
Removal
1) Disconnect negative cable at battery.
2) Disconnect connector from APP sensor assembly.
3) Remove APP sensor assembly from its bracket.
Installation
Reverse removal procedure for installation noting the
following.
• Tighten APP sensor assembly upper nut (1) first and
then lower nuts (2) to specified torque.
Tightening torque
APP sensor assembly nut (a): 6 N⋅m (0.6 kgf-m, 4.5
lb-ft)
1, (a)
2, (a)
• Connect connector to APP sensor assembly securely.
Accelerator Pedal Position (APP) Sensor
Assembly Inspection
Check APP sensor (main and sub) output voltage as
following steps.
1) For APP sensor (main), arrange 3 new 1.5 V
batteries (1) in series (check that total voltage is 4.5
– 5.0 V) and connect its positive terminal to "Vin 1"
terminal (2) and negative terminal to "Ground 1"
terminal (3) of sensor. Then using voltmeter, connect
positive terminal to "Vout 1" terminal (4) of sensor
and negative terminal to battery.
3
I5RW0A130004-01
S6RW0D1306007
4 2
1
I5RW0A130005-01
2) For APP sensor (sub), arrange 3 new 1.5 V batteries
(1) in series (check that total voltage is 4.5 – 5.0 V)
and connect its positive terminal to "Vin 2" terminal
(2) and negative terminal to "Ground 2" terminal (3)
of sensor. Then using voltmeter, connect positive
terminal to "Vout 2" terminal (4) of sensor and
negative terminal to battery.
4
3) Measure output voltage variation while accelerator
pedal is no depressed and fully depressed as
following graph.
If sensor voltage is out of specified value or does not
vary linearly as the following graph, replace APP sensor
assembly.
[C]
3.50 - 4.27 V
1.74 - 2.17 V
0.65 - 0.82 V
0.30 - 0.44 V
[D]
[C]: Voltage
[D]: Idle position of accelerator pedal
[E]: Fully depressed position of accelerator pedal
3 2
1
I5RW0A130006-02
[A]
[B]
[E]
I7RW01130020-01