Desired Sound Does Not Come Out - Marantz SR7009 Owner's Manual

Av surround receiver
Hide thumbs Also See for SR7009:
Table of Contents

Advertisement

Contents
Connections
o Desired sound does not come out
Symptom
The volume does not
0
increase.
0
No sound comes out with
0
the HDMI connection.
0
0
No sound comes out of a
0
specific speaker.
0
0
0
No sound is produced from
0
subwoofer.
0
0
0
0
0
DTS sound is not output.
0
0
Dolby Atmos, Dolby
0
TrueHD, DTS-HD, Dolby
0
Digital Plus audio is not
output.
Front panel
Display
Playback
The maximum volume is set too low. Set the maximum volume using "Limit" on the menu.
Appropriate volume correction processing is performed according to the input audio format and settings,
so the volume may not reach the upper limit.
Check the connection of the HDMI connectors.
When outputting HDMI audio from the speakers, set "HDMI Audio Out" on the menu to "AVR". To output
from the TV, set "TV".
When using the HDMI control function, check that the audio output is set to the AV amplifier on the TV.
Check that speaker cables are properly connected.
Check that a selection other than "None" is set for the "Speaker Config." setting in menu.
Check the "Assign Mode" setting in the menu.
When the sound mode is "Stereo" and "Virtual", audio is only output from the front speakers and subwoofer.
Check the subwoofer connections.
Turn on the subwoofer's power.
Set "Speaker Config." - "Subwoofer" in the menu to "1 spkr" or "2 spkrs".
When "Speaker Config." - "Front" in the menu is set to "Large", depending on the input signal and the
sound mode, no sound may be output from the subwoofer.
When no subwoofer audio signal (LFE) is included in the input signals, no sound may be output from the
subwoofer.
You can make the subwoofer always output sound by setting the "Subwoofer Mode" to "LFE+Main".
Check that the digital audio output setting on the connected device is set to "DTS".
Set "Decode Mode" on the menu to "Auto" or "DTS".
Make HDMI connections.
Check the digital audio output setting on the connected device. On some devices, "PCM" is set by
default.
Rear panel
Settings
Cause / Solution
297
Remote
Tips
Appendix
Page
Index
196
67
205
164
44
247
230
45
247
247
255
255
218
71

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents