Cub Cadet RZT-S Zero Shop Manual page 19

Seat box front main section
NOTE: There are only two reasons to remove the seat box front main section:
• To replace the deck lift shaft
• Physical damage to the seat box front main section
Blue cable
Negative cable
Figure 2.22
Blue lead
Figure 2.23
To remove/replace the seat box front main section:
The RZT-S Zero is equipped with a
! CAUTION ! CAUTION
48 volt system. Removing the pods
will expose the high voltage wiring.
1. Disconnect the battery pack's positive lead from the
contactor assembly by following the procedures
described in the left pod section of this chapter.
2. Remove the seat box top plate by following the pro-
cedures described in the previous section of this
chapter.
3. Remove the front (4
3a. Slide the battery out of the seat box assembly.
See Figure 2.22.
3b. Disconnect the negative cable from the battery.
3c. Disconnect the lead with the blue tape from the
positive terminal of the battery using a 1/2"
wrench.
Wrap the exposed cable end with
! CAUTION ! CAUTION
electrical tape or a plastic bag to
help prevent the cable from con-
tacting the frame. See Figure 2.23.
3d. Remove the battery from the mower.
th
) battery:
Body
15