Printing A Status Page - Kyocera FS-4100DN Operation Manual

Entering the Default Gateway
When DHCP is set to Off, enter the Default Gateway manually.
Default Gateway: a b
/**0.
0.

Printing a Status Page

After completing the network settings, print a status page. The status page allows you to confirm a range of information,
including network addresses and network protocols.
To print a status page, select Status Page from the Report Print menu. Refer to Report Print on page 4-10 for detailed
information.
23
Press
24
Press [OK]. The Default Gateway screen appears.
0. 0
25
Use the numeric keys or press
You can set any value between 000 and 255.
The method for entering is the same as for the IP Address.
26
Press [OK]. The default gateway is stored and the IPv4 Setting
menu reappears.
This completes the network settings. Press [Menu] and end the
mode selection menu.
or to select Default Gateway.
Note When the network settings have been changed, restart
the network card of the device. This is mandatory to make
the settings effective. For details, refer to Restart Network
(Restarting the network card) on page 4-61.
2-6
Preparation before Use
or to set the default gateway.