Format Ssd (Formatting The Ssd) - Kyocera FS-4100DN Operation Manual

RAM Disk Mode (Setting the RAM disk)
Selecting On in this setting enables the RAM disk.
RAM Disk Mode:
1 Off
********************- 2 *On
RAM Disk Size (RAM disk size setting)
Use this procedure to set the amount of memory used for the RAM disk.
RAM Disk Size:
(1-16)
/*16-MB

Format SSD (Formatting the SSD)

When an optional SSD (HD-6) is inserted into the printer for the first time, it must be formatted before use.
This menu is displayed only when the HD-6 is installed on the printer.
Note If the HD-6 is installed in the printer, the Document Box will be available. Formatting will destroy any existing
data on a storage device including a used HD-6. Formatting of the HD-6 must be executed from the printer. When
the HD-6 has not yet been formatted, the Attention indicator flashes and Format SSD is displayed.
Use the procedure below to format the HD-6.
When a new HD-6 is inserted in the printer's slot, Format SSD will appear on the message display.
1
In the RAM Disk Setting menu, press
Mode.
2
Press [OK]. The RAM Disk Mode screen appears.
a b
3
Press
4
Press [OK]. The RAM disk setting is set and the RAM Disk
Setting menu reappears.
1
In the RAM Disk Setting menu, press
Size.
2
Press [OK]. The RAM Disk Size screen appears.
a b
3
Use the numeric keys or press
to be used as a RAM disk.
The maximum amount of memory that can be set varies depending
on the total amount of memory in the printer.
4
Press [OK]. The amount of memory used as a RAM disk is stored and
the RAM Disk Setting menu reappears.
When you have completed the setting, exit the menu and restart the
printer. The selected setting is valid after the printer starts up again.
1
In the Device Common menu, press
4-82
or to select whether the RAM disk is enabled.
or
Operation Panel
or to select RAM Disk
or to select RAM Disk
to set the amount of memory
or to select Format SSD.