Installing The Wired Remote Control For Monobloc Systems - Panasonic WH-MDF09C3E5 Installation Manual

Electrical installation
Installing the wired remote control

8.4 Installing the wired remote control for monobloc systems

Warning!
8 – 66 Aquarea air/water heat pump – Installation manual for monobloc and split systems C, D and E series 05 / 2014
Please follow these instructions to prevent damage and problems:
• Do not change the length of the cable for the wired remote control .
• Install the wired remote control cable at least 5 cm away from other
electric cables .
• Do not install the wired remote control cable in the immediate vicinity
of water or condensate pipes .
• The installation location must be dry .
• The wired remote control must be installed so that it is not exposed
to direct sunlight .
• Mount the wired remote control in as level a location as possible
to prevent the wired remote control bending .
• Observe the minimum clearances as shown in the following diagram:
Component
Remote control
Remote control cable
Screw (M4 × 30 mm
machine screw)
Screw (M4 × 14 mm
self-tapping screw)
Included accessories
Quantity Comment
1
1 15 m long
3 For installing the remote control on an
outlet (embedded connection cable)
3 Installing the remote control on the
wall (exterior connection cable)