Assembly; Attach Handle To Vaccum/Vacuum Hose/Tools - Bissell POWERFORCE HELIX 1240 series User Manual

Assembly

You will need a Phillips screwdriver for assembly.
Attach handle to vaccum
1. Locate handle and remove screw packet
taped to the base of the handle.
2. Stand the vacuum upright and place the
base of the handle firmly into the grooves at
the top of the vacuum body.
3. Insert the two (2) screws into the existing
holes on each side and tighten securely.
Attach vacuum hose and tools
1. Line up tabs on the base of the Twist 'n
Snap™ hose with the corresponding notches
on the hose collar. Turn the hose to the right
to lock into place.
2. Grasp the Quick Reach handle and slide the
end of the hose into the Hose Wand Base. Snap
the hose into the upper hose clip on handle.
3. Slide the extension wand and crevice tool
together into storage clip.
4. Snap the combination tool into the
storage clip.
Select models only:
5. The TurboBrush® Tool bracket slides into
the front of the handle. Attach the bracket by
aligning the pegs with the holes on the handle
and pulling down until it locks into place.
6. Place the TurboBrush® Tool in the bracket
by aligning the bottom of bracket with the
opening of the brush roll and snap the
TurboBrush® Tool into place.
1.
» Hold onto the plastic hose
1. 2.
3. 4.
5. 6.
www.BISSELL.com
Tip
collar while installing. It may
be easier to lock the hose
into place when the hose
handle is not yet inserted
into the base of the unit.
5