Using The Belt Clip - Uniden XDECT SSE27 series Owner's Manual

4) Place the cover
over the battery
compartment and slide it
up into place.
Connect the charger
1) Connect a charger AC adapter to each
charger's
DC IN 9V
plug into the notch as shown.
2) Plug the other end of the adapter into
a standard 240V AC power outlet.
3) Place each handset in a charger with
the display facing forward. The
If...
the
CHArGE
doesn't turn on
Charge all handsets completely (about 15 hours)
before using them.
Test the connection
Pick up each handset and press
dial tone, and the display should say Talk. (Press
If you can't get a dial tone or the handset display says Unavailable, try
moving the handset closer to the base or resetting it (see page 31).

Using the Belt Clip

To attach the belt clip
Line up the holes on each side of the handset. Insert the belt clip into the
holes on each side of the handset. Press down until it clicks.
To remove the belt clip
Pull either side of the belt clip to release the tabs from the holes.
jack and set the
Try...
-
light reseating the handset.
-
checking the AC adapter connection.
light should turn on.
CHArGE
. You should hear a
TAlk
again to hang up.)
TAlk
5