Table of Contents
Advertisement
7
Remove existing wall plate.
Î Note: During this process, make sure that the wires do not pull back into wall
Î
opening.
a.
Detach all wires from wall plate.
b.
Remove all screws attaching the wall plate to the wall and remove wall plate.
Î See MercuryÎNotice on page 2.
Î
8
Separate the face of the new thermostat from the wall plate.
Apply pressure at two tabs on top of wall plate to release it.
Î NOTE: It is not recommended that this Z-wave
Î
structures. Metal may adversely affect the radio frequency (RF) communication
between the thermostat and the Z-wave
9
Mark two mounting holes using new wall plate.
a.
Pull wires through hole in center of wall plate.
b.
Locate the new wall plate over existing opening.
c.
Mark two holes with pencil.
d.
Use a level to verify that the two hole locations are level.
e.
Correct hole locations as needed.
10
Prepare two mounting holes.
a.
Drill 1/16" pilot holes in the two locations that were marked in step 9. If mounting to
drywall with no studs behind it, enlarge pilot holes to 1/8" for anchors (included with
the thermostat).
b.
If using anchors, screw them into the holes.
TM
thermostat be mounted onto metal
TM
bridge.
Wall plate
Tabs
Wall plate
Anchors
5
Hide quick links:
Advertisement
Table of Contents
