Specifying A Server For The Dhcp Client; Configuring Option 184 Parameters For The Client - HP 5920 Series Configuration Manual

Step
3. Specify the IP address or the
name of a TFTP server.
4. Specify the boot file name.

Specifying a server for the DHCP client

Some DHCP clients need to obtain configuration information from a server, such as a TFTP server. You
can specify the IP address of that server. The DHCP server sends the server's IP address to DHCP clients
along with other configuration information.
To specify the IP address of a server:
Step
1. Enter system view.
2. Enter DHCP address pool
view.
3. Specify the IP address of a
server.

Configuring Option 184 parameters for the client

To assign calling parameters to DHCP clients with voice service, you must configure Option 184 on the
DHCP server. For more information about Option 184, see
To configure option 184 parameters in a DHCP address pool:
Step
1. Enter system view.
2. Enter DHCP address pool view.
3. Specify the IP address of the
primary network calling processor.
4. (Optional.) Specify the IP address
for the backup server.
Command
•
Specify the IP address of the TFTP
server:
tftp-server ip-address ip-address
•
Specify the name of the TFTP server:
tftp-server domain-name
domain-name
bootfile-name bootfile-name
Command
system-view
dhcp server ip-pool pool-name
next-server ip-address
Command
system-view
dhcp server ip-pool pool-name
voice-config ncp-ip ip-address
voice-config as-ip ip-address
36
Remarks
Use either command.
By default, no TFTP server is
specified.
By default, no boot file
name is specified.
Remarks
N/A
N/A
By default, no server is
specified.
"Option 184."
Remarks
N/A
N/A
By default, no primary
network calling processor is
specified.
After you configure this
command, the other Option
184 parameters take effect.
By default, no backup
network calling processor is
specified.