Gre Over Ipv6 Configuration Example - HP 5920 Series Configuration Manual

# From Switch B, ping the IP address of VLAN-interface 100 on Switch A.
[SwitchB] ping -a 10.1.3.1 10.1.1.1
PING 10.1.1.1 (10.1.1.1) from 10.1.3.1: 56 data bytes
56 bytes from 10.1.1.1: icmp_seq=0 ttl=255 time=11.000 ms
56 bytes from 10.1.1.1: icmp_seq=1 ttl=255 time=1.000 ms
56 bytes from 10.1.1.1: icmp_seq=2 ttl=255 time=0.000 ms
56 bytes from 10.1.1.1: icmp_seq=3 ttl=255 time=0.000 ms
56 bytes from 10.1.1.1: icmp_seq=4 ttl=255 time=0.000 ms
--- 10.1.1.1 ping statistics ---
5 packet(s) transmitted, 5 packet(s) received, 0.0% packet loss
round-trip min/avg/max/stddev = 0.000/2.400/11.000/4.317 ms
The output shows that Switch B can successfully ping Switch A.

GRE over IPv6 configuration example

Network requirements
Two IPv4 subnets Group 1 and Group 2 are connected to an IPv6 network. Create a GRE over IPv6
tunnel between Switch A and Switch B, so the two IPv4 subnets can communicate with each other
through the GRE tunnel over the IPv6 network.
Figure 82 Network diagram
Switch A
XGE1/0/3
XGE1/0/1
Vlan-int100
10.1.1.1/24
IPv4
Group 1
Configuration procedure
Before the configuration, make sure Switch A and Switch B can reach each other.
Configure Switch A:
1.
# Configure interface VLAN-interface 100.
<SwitchA> system-view
[SwitchA] vlan 100
[SwitchA-vlan100] port Ten-GigabitEthernet 1/0/1
[SwitchA-vlan100] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ip address 10.1.1.1 255.255.255.0
[SwitchA-Vlan-interface100] quit
# Configure interface VLAN-interface 101.
[SwitchA] vlan 101
[SwitchA-vlan101] port Ten-GigabitEthernet 1/0/2
[SwitchA-vlan101] quit
XGE1/0/2
Vlan-int101
2002::1:1/64
IPv6 network
GRE tunnel
Tunnel0
10.1.2.1/24
Service loopback port
XGE1/0/2
Switch B
Vlan-int101
2001::2:1/64
XGE1/0/3
XGE1/0/1
Vlan-int100
Tunnel0
10.1.3.1/24
10.1.2.2/24
IPv4
Group 2
187