Q-Box & Pd-Board Removal - Sony KDS-R50XBR1 Training Manual

Q-Box & PD-Board Removal
TVP-21
Access & Removal of Q -Box & PD-Board
Wire Holders
USB Cable
Screws
indicated by
red circles
DMB Outer
Shield
Small
Cover
(Digital Module Block DMB )
Slide Out
Wire Holders
Connector
Cover
I-Link
Jack
Screws
(on side )
Disassembly Procedures
1
The Chassis only needs to be
slightly slid out to access the
screws and wire holders to
access the Q-Box and PD-
board.
Reference the "Complete PCB
Chassis" section for details to
free and slide out the chassis .
Remove all wires from wire
holders.
Disconnect USB cable
2
Remove 16 screws, Small
Cover, and the Connector
Cover to remove DMB outer
shield.
When all screws are removed,
pull the left-side of the shield
out first to clear the i -link
connectors on the right -side of
the shield.
Once i-link connectors are clear
pull shield straight off.
35