Sony KDS-R50XBR1 Training Manual page 112

H/V Center Adjustment Procedure
Check H/V center with a monoscope

pattern with wide mode set to Full.
Cross hair test pattern #11 can be
used if no other source is available)
To adjust H/V center take the following

steps:
Enter service mode:

+ [Power].
Press [JUMP] button on remote three

times until you arrive at PANEL service
mode.
Scroll to Device "TG" by pressing the [2]

button one time.
Once in Device "TG" scroll to item 4

"VST_POS" to adjust vertical center.

Scroll to item 5 "HST_POS" to adjust

horizontal center.

* Note after adjusting press [mute] +
TVP-21
[Display] + [5] + [Vol. +]
Use the [3] and [6] buttons to adjust as
needed.
Use the [3] and [6] buttons to adjust as
needed.
[enter] to write new settings.
(QM
Appendix
109