Chassis Assembly Removal
TVP-21
Removal of Complete Chassis Assembly
Screw
Disconnect
C-Brd
Connector
2 Screws
3 Screws
Small
Cover
Screws
Disconnect C-
Board cables
Vertical Bracket
DMB
Becareful of
Lift
Cables
Tabs
1
Remove 6 screws and
disconnect the C-Board ribbon
cable (Gentle press the Tan tab
on the side of the connector to
release cable.
Tan Tab
2
Remove the small cover (3 screw)
and disconnect C-Board cables.
Also remove 1 screw under DMB
securing the chassis assembly.
CAUTION:
Be extremely careful not to damage
C-Board cables while removing the
Chassis Assembly.
3
Lift the two locking tabs and slide
chassis straight out until it is
stopped by the vertical bracket
(right side) .
CAUTION:
Be extremely careful not to damage
C-Board cables when sliding the
chassis out. Gentle push cables
under the DMB assembly.
Bracket stops
chassis
Disassembly Procedures
27