Router Installation - AT&T Plug&Share 6800G User Manual

Getting Started
Step 1: Make sure that you have Internet access
Before you begin, launch your web browser to make sure you can connect to the Internet. If you can
connect to web sites as usual, proceed to Step 2, below. If you cannot connect to the Internet, check
your modem connections, or consult the User Manual provided by your broadband/Internet service
supplier. You must have Internet access before installing the router.
Step 2: Connect router to your cable/DSL modem and to your computer
1 Connect power adapter
Connect the power adapter to
the router, then plug it into an
electrical outlet not controlled by
a wall switch.
2 Connect router to computer
Unplug the Ethernet cable from
your modem, then plug it into
the LAN 1 port of the router.
(You can use the other ports to
connect devices not equipped
for wireless networking).
3 Connect router to modem
Use the supplied Ethernet cable
to connect the modem to the
WAN port of the router. WAN
stands for Wide Area Network
(Internet).
4 Check lights & connections
Before proceeding, make sure
all connections match the
diagram at right. Check the front
of the router to make sure the
Power, WAN and LAN1 lights
are on (see page 6).
AT&T Plug&Share 54 Mbps Wireless Router 6800G
™
Rotate antenna to
fully upright position
Ethernet
Cables
Power Adapter
Computer
Modem
7