The Dispenser - Samsung RS27FDBTNSR Series Quick Start Manual

PROBLEM
Display does
not work!
Photos not
showing with a
memory card
connected.
The LCD
screen turns
off frequently.
There is an
after image
or an edge
line left on the
screen.
The input point
of the touch
screen is not
correct.
After you
turn on the
power, only

the dispenser

selection
button
operates.
There is no
wireless router
detected.
SOLUTION
• Press the Reset button over one second to reset the memory.
With this, the user information is not to be reset.
• If the "Memory card is connected" messages do not appear on the screen, check if the memory
type is SD / SDHC / MMC / HS MMC.
• Check if there are photos or images stored in the memory card.
• Check if the images in the memory card are JPEG (JPG) types.
• This is a power-saving function and it is normal.
• On Settings-Display, you can set the Screensaver Running Time.
• Still images can cause permanent damage to the LCD screen.
When you select Screensavers, select a number of themes so the image changes frequently.
NOTE : Defects caused by this are not be covered by the factory warranty.
• Run the Touch Screen Calibration function at the Settings.
• Click the "Dispenser OK" button which is at the bottom of the display.
If the ""Dispenser OK" button changes to "Complete", turn the power off and on again. The
display should show the "Home screen".
• Check if the power for the wireless router is on.
• Check if the wireless router supports IEEE 802.11 b/g/n.
• Check if other devices (Notebook PC, Smart phone etc.) can access the wireless router. If
wireless router can not be accessed by the other devices, the wireless router probably has a
problem.
Please contact with wireless router manufacturer.
• If the wireless router is located far away from the Fridge, move the wireless router closer to the
Fridge and see if the fridge detects it.
• Turn the power of both the Wireless router and the Fridge off and on.