Critical Installation Warnings - Samsung RS27FDBTNSR Series Quick Start Manual

CRITICAL TRANSPORTATION AND SITE WARNINGS
• When transporting and installing the appliance,care should be taken to ensure that no parts of the refrigerating
circuit are damaged.
• R-600a or R-134a is used as a refrigerant.
Check the co mpressor label on the rear of the appliance or the rating label inside the refrigerator to see which
refrigerant is used for your refrigerator.

CRITICAL INSTALLATION WARNINGS

• Do not install this appliance near a heater, inflammable material.
• Do not spray inflammable gas near the refrigerator.
- There is a risk of explosion or fire.
• Do not install this appliance in a humid, oily or dusty location, in a location exposed to direct sunlight and water (rain
drops).
- Exposure can cause insulation to deteriorate. Deteriorated insulation on electrical parts may cause electric shock or
fire.
• Do not place this refrigerator in direct sunlight or expose to the heat from stoves, room heaters or other appliances.
• Do not plug several appliances into the same multiple power board.
The refrigerator should always be plugged into its own individual electrical outlet which has a voltage rating that
matched the rating plate.
- This provides the best performance and also prevents overloading house wiring circuits, which could cause a fire
hazard from overheated wires.
• If the wall socket is loose, do not insert the power plug.
- There is a risk of electric shock or fire.
• Do not use a cord that shows cracks or abrasion damage along its length or at either end.
• Do not bend the power cord excessively or place heavy articles on it.
• Do not use aerosols near the refrigerator.
- Aerosols used near the refrigerator may cause an explosion or fire.
• Do not install this appliance in a location where gas may leak.
- This may result in an electric shock or fire.
• We strongly recommend you use a qualified technician or service company to install or service the refrigerator.
- Failing to do so may result in an electric shock, fire, explosion, problems with the product, or injury.
• This refrigerator must be properly installed and located in accordance with the manual before it is used.
• Connect the power plug in proper position with the cord hanging down.
- If you connect the power plug upside down, wire can get cut off and a cause fire or an electric shock.
• Make sure that the power plug is not squashed or damaged by the back of the refrigerator.
• When moving the refrigerator, be careful not to roll over or damage the power cord.
- This constitutes a fire hazard.
• The appliance must be positioned so that the plug is accessible after installation.