Using The Parts List - Xerox Phaser 6020 Service Manual

Parts List

Using the Parts List

Only parts showing part numbers are available for ordering by support. Parts not showing part
numbers are available on the parent assembly.
Item: The callout number from the exploded part diagram.
•
Name/Description: The name of the part to be ordered and the number of parts supplied per
•
order.
Part Number: The material part number used to order that specific part.
•
Parts identified throughout this manual are referenced PL#.#.#; For example, PL3.1.10 means the
•
part is item 10 of Parts List 3.1.
• A Black triangle preceding a number followed by a parenthetical statement in an illustrated parts
list means the item is a parent assembly, made up of the individual parts called out in
parentheses.
The notation "with X~Y" following a part name indicates an assembly that is made up of
•
components X through Y. For example, "1 (with 2~4)" means part 1 consists of part 2, part 3, and
part 4.
• An asterisk (*) following a part name indicates the page contains a note about this part.
The notation "J1<>J2 and P2" is attached to a wire harness. It indicates that connector Jack 1 is
•
attached to one end of the wire harness and connector J2 is attached to the other end that is
plugged into P2.
• Fastener location and type are indicated using designators listed in the following table. Refer to
"Fastener Types" on page 4-4" for a complete list of fasteners used, and "Hardware Kit" on
page 5-98 for fasteners available in the Hardware Kit.
Designator
E
KL
ST
SM
5-4 Phaser 6020/6022 and WorkCentre 6025/6027 MFP
Service Manual
Fastener Type
E-ring
K-clip
Screw, self-tapping
Screw, sheet metal