Checking The Network Operating Status; Checking The Network Status - Fujitsu N7100 Operator's Manual

4.8.2 Checking the Network Operating Status

■ Checking the Network Status

The operating status of the network can be checked.
If the information is not shown, the network may not be operating normally. Refer to
Network Connection Troubleshooting" (page
1. Select [Network Status] under [Check Network Status].
 The [Network Status] window shows the status of the currently operating network
connection.
HINT
 If connection to LDAP server is not possible, try the following steps:
1. Disconnect the LAN cable.
2. Press the [Shutdown] button on the touch panel to turn the scanner off.
3. Press the power button to start the scanner with the LAN cable disconnected.
4. Enter a non-duplicated IP address.
5. Re-connect the LAN cable to the scanner.
 If the DHCP server cannot be reached when DHCP is set to [On], the IP address is set
to "169.254.X.X" (where X is an arbitrary value between 0 and 255).
4.8 Checking the Network Status
Touch
Panel
357), and check the settings.
107
"7.2