Spirit XE195 Owner's Manual page 10

STEP 4: Plastic Parts
1. Fasten the two Wheel Covers (79) to the rollers with four Phillips Head Screws
(115).Tighten with the Phillips Head Screw Driver (157).
2. Attach the left and right side cover (80) to the mid-stabilizer tube with two Phillips Head
Screws (115). Attach the right side cover
tube with two Phillips Head Screws (115).Tighten all four screws with the Phillips Head
Screw Driver (177).
3. Install the Left Handle Bar Covers (81 & 82) and Right Handle Bar Covers (83 & 84) over
the Handle Bar axle connections with four Sheet Metal Screws (119) on each side. Tighten
with the Phillips Head Screw Driver (157).
4. Look closely at the four floor levelers underneath the middle and rear of the elliptical. If any
of these aren't in contact with the floor, use the Wrench
Once the nut has been loosened, turn the rubber caster clockwise until it makes solid
contact with the floor. Retighten the bottom nut to prevent it from moving.
HARDWARE
#119. Ø 3.5 × 12mm
Sheet Metal Screw (8 pcs)
(86) and left side cover
#115. M5 × 12mm
Phillips Head Screw (8 pcs)
10
(85) to the rear stabilizer
(158) to loosen the bottom nut.