Conventions Used In This Manual - Rinnai RHFE-308FTR Installation Manual

CONVENTIONS USED IN THIS MANUAL

The following symbols are used to highlight sp eci c requirements during installation steps.
CLEARANCES
Where required clearances will be provided and must be observed.
FALL
Ensure that the specified 2° fall is maintained to either the terminal or condensate trap.
MEASURE
Required measurements will be provided and MUST BE observed for correct installation.
CUT
Cut as required to the specified measurements.
FINISH
Ensure that burrs and swarf are removed from all cut ends.
DISCARD
Denotes items that are not required for the specific installation.
OBSERVE CORRECT ORIENTATION
Where specified ensure that components are installed with the correct vertical or horizontal
orientation.
LUBRICATE
Use the supplied container of silicon grease to lubricate components.
lubricants as these may damage the flue components.
SECURE
Where specified secure components with either installer provided or component supplied fixings.
DO NOT
Failure to observe
injury or death.
NOTE / IMPORTANT
!
Important notes or general hints and guides provided to ease the installation.
CAUTION
!
Caution notes and or warnings that MUST BE observed for safe and correct installations.
The heater and the flue system shall be installed in accordance with the following:
Rinnai New Zealand Ltd.
DO NOT instructions will void the warranty of an appliance and may cause
1
DO NOT use other
ES Flue Installation Manual