Advertisement
F E AT U R E S - O P E R AT I O N S
1. Set fan on a dry, level surface.
2. Plug cord into any standard 120 volt AC outlet.
3. The speed/mode is adjustable by pushing the
Mode/O button located on the front of the control
housing. Each push of the button will cycle through
Manual High (II), Manual Low (I), Auto High 15°C,
18°C, 21°C, 24°C, 27°C (60°F, 65°F, 70°F, 75°F,
80°F), Auto Low 15°C, 18°C, 21°C, 24°C, 27°C
(60°F, 65°F, 70°F, 75°F, 80°F) and then to OFF (O).
Note that if you hold the Mode/O button down for 3
seconds, the fan will turn off while remembering its last
setting. The last fan setting will return when turned on
again.
REMOTE CONTROL INSTRUCTIONS
This unit requires 2 AAA batteries, 1.5V (not included).
1. Insert 2 AAA batteries (not included) into back of
remote control.
2. Press the Mode/O button on remote to begin
operation.
3. Use the remote to control the same features as the
base unit.
Battery Replacement
a) Remove battery cover from remote control.
b) Remove old batteries from the remote control.
c) Insert two new batteries, pressing them firmly into
their slot.
d) Replace the battery cover.
NOTE:
• Replace all batteries of a set at the same time.
• Being careful not to bend or damage the contact
spring, clean the battery contacts and devices'
contacts prior to installing the batteries.
• Remove the batteries from the equipment when it is
not being used for an extended period of time.
• Remove the used batteries promptly.
• Do not mix old and new batteries. Do not mix
alkaline, standard (carbon-zinc), or rechargeable
batteries.
• Do not discard used batteries into household trash
containers. Contact your local government for
disposal or recycling practices in your area.
This Class B digital apparatus complies with Canadian
ICES-003.
ADJUSTMENT INSTRUCTIONS
Fan Head Tilt-Adjustment
1. To change the tilting angle of the fan head, simply
loosen the Tilt-Adjustment Knob.
2. Move the fan head to the desired angle and firmly
tighten the Tilt-Adjustment Knob to lock into place.
Reduced Height Adjustment
3. Remove the lower extension pole for reduced height.
Oscillation
The Oscillation Switch (
the fan motor housing. To start Oscillation, push control
knob down. To stop Oscillation, pull control knob up.
) is located at the back of
Advertisement
