Advertisement
F E AT U R E S - O P E R AT I O N S
3. Add the fan head locking knob (L) to the hole in the
fan head's neck (M), making sure holes are aligned,
and tighten.
Converting to a Table Fan
An additional short pole (Q) is supplied which allows the
fan to be converted into a table fan (see Fig. 2). To
change to this short pole, remove the fan head assembly
from its position on top of the inner pole extension (N)
and unscrew the T-shaped locking lever (U) at the base.
Remove the outer pole (P), replace with the short pole
(Q) and reassemble as detailed above.
Fig. 2
Base Cover
Additional Short Pole
OPERATING INSTRUCTIONS
1. Set fan base on a dry, level surface.
2. Plug cord into any standard 120 volt AC outlet.
Please make sure the Speed Control Knob is in the
OFF (O) position. Speed Control Knob is located on
the Fan Motor Housing.
3. The SPEED is adjusted by turning the Speed Control
Knob to the desired setting, O-3-2-1.
4. The OSCILLATION control knob is located on the top
of the Fan Motor Housing. To start Oscillation, push
Control knob down. To stop Oscillation, pull Speed
Control Knob up.
ADJUSTMENT INSTRUCTIONS
Tilt-Adjustment
Follow these instructions to tilt the Fan Head for upward
angle air movement.
1. To change the tilting angle of the fan head, simply
loosen the tilt-adjustment knob (K).
2. Move the fan head to the desired angle and firmly
tighten the tilt-adjustment knob to lock into place.
Height Adjustment
Follow these instructions to adjust the height of the fan.
1. Turn the pole locking knob (O) counter-clockwise to
loosen the pole.
2. Adjust the pole to the desired height and firmly
tighten the locking knob in a clockwise direction.
Advertisement
